Integration with STP Documents

Integration with LEXolution.DMS

All documents created by LEXolution are stored in LEXolution.DMS.
Only system templates are stored in the document directory.

Integration with LEXolution.DMS is optional.
To use the LEXolution.DMS integration, LEXolution.DMS must be installed.
The installation and configuration of LEXolution.DMS is not covered by this installation guide.

If LEXolution.DMS is already in use, please contact Support@stp.one.

Configuring the LEXolution.DMS integration
To configure the integration with LEXolution.DMS, follow these steps:

Step 1
Open the LEXolution Server configuration file with administrator privileges.
If you installed the LEXolution Server in the default installation directory, the configuration file STP.Kms.Server.exe.config is located in the directory C:\Programme (x86)\STP AG\LEXolution.KMS-Server\.

Under DmsType, specify that LEXolution.DMS should be used instead of Filesystem.
For LEXolution.DMS up to version 6.5, enter the following value:

<add key="DmsType" value="LEXolutionDMS"></add>

For LEXolution.DMS version 7 and later, enter the following value:

<add key="DmsType" value="LEXolutionDMS7"></add>

Starting with LEXolution version 6.1.132 / 6.1.1003, the full functionality of the DMS controls is available in the DMS integration in LEXolution with LEXolution.DMS 7.5.112.
If you are using LEXolution.DMS version 7.5.112 or later, we strongly recommend using the new interface for LEXolution 9.3.66.
As of LEXolution.DMS version 7.6.323, KMS can no longer be used via the DMS7 interface, as DMS Controls 7.0 are no longer compatible with LEXolution.DMS 7.6.323.

For LEXolution.DMS version 7.5.112 and later, enter the following value:

<add key="DmsType" value="LEXolutionDMS73"></add>.

Under LexDmsCommunicationFolder, specify where the communication path is stored:

 <add key="LexDmsCommunicationFolder" value="\\<Servername>\<Kommunikationspfad>"></add>

Step 2
Save the changes and close the configuration file.
Stop the STP LEXolution Server service and restart it. >> The updated settings have been applied.
The STP LEXolution Server service is running. The LEXolution Server is installed and configured.

After the LEXolution.DMS integration has been configured, the LEXolution.DMS migration tool must be run.
The configuration and documentation of the LEXolution.DMS migration tool is not covered by this installation guide and can only be carried out by an STP Informationstechnologie GmbH employee.

Once the LEXolution.DMS migration tool has been run, the integration should not be reverted, as doing so may lead to data inconsistencies.